College of Engineering and Computer Science-Mechanical Engineering

Mechanical Engineering
California State University Fullerton
College of Engineering and Computer Science

ME Home

Message From Chair

Mission and Objectives

Program Outcomes

Bachelor Degrees in Mechanical Engineering

Bachelor Degree with Manufacturing Emphasis

MS in Mechanical Engineering

Course List

Faculty

ECS Home

Manufacturing Engineering Emphasis

Students pursuing the Bachelor's degree in mechanical engineering with an emphasis in manufacturing engineering must complete a total of 139 units. These include: 33 units of lower-division mathematics and science courses; 22 units of core engineering courses; 45 units of required mechanical engineering courses; 6 units of technical electives; and 33 units of General Education courses. Before enrolling in any elective course, approval of the Department Advisor must be obtained.

Required Courses (45 units)
Course	Description	Units
EGEE 303	Electronics	3
EGEE 303L	Electronic Instrumentation	1
EGME 306B	Fluids and Thermal Laboratory	1
EGME 315	Basic Fabrication Techniques and Manufacturing Practices	3
EGME 322L	Introduction to Comptuer-Aided Design	3
EGME 331	Mechanical Behavior of Materials	3
EGME 333	Fluid Mechanics and Aerodynamics	3
EGME 335	Introduction to Mechanical Design	3
EGME 407	Heat Transfer	3
EGME 414	Design Project I	3
EGME 419	Design Project II	2
EGME 421	Mechanical Design	3
EGME 426	Design of Thermal and Fluid Systems	3
EGME 461	Fabrication Methods	3
EGME 463	Introduction to Robotics	3
EGME 476A	Dynamic Systems and Controls Lab	2
EGME 483	Computer-Integrated Manufacturing	3

Technical Electives (6 units)
Before enrolling in any elective course approval of the advisor must be obtained.
Course	Description	Units
EGME 410	Introduction to the Finite Element Method and Applications	3
EGME 411	Mechanical Control Systems	3
EGME 454	Optimization of Engineering Design	3
EGME 459	Plastics and Other Non-Metallics	3
EGME 460	Failure of Engineering Materials	3
EGME 462	Composite Materials	3
EGME 480	Human Factors in Engineering	3
EGCE 408	Reinforced Concrete Design	3
EGEE 404	Introduction to Microprocessors and Microcomputers	3
EGEE 404L	Introduction to Microprocessors and Microcomputers Lab	1
EGEE 445	Digital Electronics	3
EGEE 445L	Digital Electronics Lab	1
EGEE 465	Introduction to VLSI Design	3

This page is maintained by the Cal State Fullerton department of Engineering and Computer Science. Report problems to ecswebmaster@fullerton.edu.

California State University, Fullerton ©2003. All Rights Reserved. This site may contain links to Web sites not administered by California State University, Fullerton, or one of its divisions, schools, departments, units or programs. California State University, Fullerton, is not responsible or liable for the accuracy or the content of linked pages.